Allgrip Prepack

Allgrip Hammer Screws 8 x 100mm, Nylon, supplied in a pack of 10.

Hammer-in screws are a nylon plug with a pre-fitted screw that is driven with a hammer for fast fixing of battens, cable trunking and light brackets to masonry. Drill the hole, insert and hammer home.

Can be unscrewed for removal. Supplied in a barcoded Allgrip retail prepack.

Allgrip Coach Screws 10 x 100mm, BZP, supplied in a pack of 5.

Coach screws are a heavy gauge timber screw with a hex head for spanner or socket driving and a coarse thread for a strong grip in wood. Used for structural timber fixing: sleepers, gate posts, joist hangers and heavy brackets.

Pre-drill a pilot hole to avoid splitting and to make driving easier. Supplied in a barcoded Allgrip retail prepack.

Allgrip Woodscrew No.10 x 1in, Round, Japanned, Black, supplied in a pack of 25.

Countersunk Pozi woodscrews are the general purpose screw for timber, joinery, chipboard and MDF. The countersunk head sits flush and the Pozi drive gives a positive grip with the bit.

Pre-drill hardwoods and near board edges, and drive with a Pozi bit at a steady speed. Supplied in a barcoded Allgrip retail prepack.

Allgrip Masonry Nails 3.0 x 60mm, supplied in a pack of 12.

Hardened masonry nails drive directly into brick, block and mortar joints without drilling or plugging. Used for fixing battens, cable clips, straps and light brackets to masonry.

Strike squarely with a club hammer and wear eye protection. Supplied in a barcoded Allgrip retail prepack.

Allgrip Frame Fixings 10 x 140mm, Nylon, supplied in a pack of 6.

Frame fixings anchor window frames, door frames, battens and skirtings directly to masonry in one operation. Drill through the frame and into the wall, insert the plug and drive the screw to expand it and pull the frame tight.

The nylon sleeve is corrosion free and will not seize in damp conditions. Supplied in a barcoded Allgrip retail prepack.

Allgrip Cup Square Hex Bolts in A2 stainless steel, available in M8, M10 and M12 diameters across a range of lengths, each supplied in a barcoded Allgrip retail prepack.

Cup square bolts have a smooth domed head with a square shoulder that bites into timber as the nut is tightened, so the bolt cannot spin and no spanner is needed on the head side. A2 stainless steel resists rust and staining indoors and out, making it the right choice for gates, fencing, decking frames, sleepers and outdoor timber structures where a zinc plated bolt would corrode or mark the timber.

Pre-drill a clearance hole through both timbers, insert the bolt and tighten from the nut side with a spanner or socket. Select the size below.